Hi,

I recently purchased TS2.5 and started evaluating it. I've some questions about Charts that i open after a session has been run.

1. What does the indicator High/Low bands mean? When i configure and open them, i see 3 lines in the chart. I was expecting only two: high and low. What does this indicator mean ?

2. After an indicator has been configued, how do i remove the indicator from the chart ? I was searching for any "delete indicator" menu item, but didn't find any.

3. If i choose the high/low bands indicator and enter the Periods as 5, then it gives an error "Run time error 5208; Invalid Periods(min 6) for indicator high/low bands". Why can't a value less than 6 can be entered for the high/low bands ?

-Regards

Vinoth

Indicators appear on the chart in the left hand object panel you can right click on them and change properties or delete them.

 I will check into the band indicator and see if I can duplicate your issue.

The center band is like a average between the high low bands. Like a bollinger band.

That indicator has a minimum value of six which is allowed. It should not crash if you put 3 in, I will get this fixed in the next release.